Axxess AX-CH013-SWC 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Axxess AX-CH013-SWC에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-CH013-SWC 12 페이지. Chrysler data interface with swc2004-up

PROGRAMMING THE AX-CH013-SWC

For the steps below, the L.E.D. located inside the interface can only be seen while active. The

interface does not need to be opened to see the L.E.D.

• Start the vehicle.

• Connect the AX-CH013-SWC harness to the wiring harness in the vehicle.

• The L.E.D. will initially turn on solid Green, then turn off for a few seconds while it auto

detects the radio installed.

• The L.E.D. will then flash Red up to (18) times indicating which radio is connected to the interface,

and then turn off for a couple of seconds. Pay close attention to how many Red flashes there

are. This will help in troubleshooting, if need be. Refer to the L.E.D. feedback section for more

information.

• After a couple seconds the L.E.D. will turn on solid Red while the interface auto detects

the vehicle. The radio will shut off at this point. This process should take 5 to 30 seconds.

• Once the vehicle has been auto detected by the interface, the L.E.D. will turn on solid

Green, and the radio will come back on, indicating programming was successful.

• Test all functions of the installation for proper operation, before reassembling the dash. If

the interface fails to function, refer to Resetting the AX-CH013-SWC.

Note: The L.E.D. will turn on solid Green for a moment, and then turn off under normal

operation after the key has been cycled.

Audio level adjustment (amplified models only):

• With the vehicle and radio turned on, turn the volume up 3/4 of the way.

• With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio

level; counterclockwise to lower the audio level.

• Once at a desired level, audio level adjustment is complete.