Axxess AX-MLINK-AVHD 설치 지침

{카테고리_이름} Axxess AX-MLINK-AVHD에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AX-MLINK-AVHD 3 페이지. Car audio wi-fi a/v mirror interface through hdmi or aux/av-in

페이지 인쇄

Car audio Wi-Fi A/V mirror interface

through HDMI

With this Wi-Fi interface you will be able to mirror your iOS

in-dash mobile video screen.

Note: This will not allow the mobile device to be operated from the aftermarket in-dash mobile video

screen. All operations (button presses) will need to be executed from the mobile device.

Mirroring capabilities are determined by the smart devices' (phone, tablet, etc.) software and the network

provider's permissions given to the device. Software updates can change the devices ability to mirror

certain types of video/audio.

• AX-MLINK-AVHD interface • AX-MLINK-AVHD harness • Wi-Fi antenna (qty. 2)

1. Antenna connector (qty. 2): For connecting

the external Wi-Fi antennas.

2. Micro "B" USB: Optional portable power

source (5-volts 1-amp required)

Note: Not recommended for streaming video.

3. HDMI

port: Output to aftermarket in-dash mobile

™

video screen (HDMI

cable sold separately).

™

Axxess Integrate

Installation instructions for part AX-MLINK-AVHD

AX-MLINK-AVHD

or AUX/AV-IN

™

or Android

INTERFACE COMPONENTS

INTERFACE DESCRIPTION

4. ACC+CVBS connector:

(a) Power cable connections to ACC/GND.

(b) CVBS cable connections to aftermarket in-dash

mobile video screen AUX/AV-IN (Red, White &

Yellow RCA jacks).

(d) USB: For software upgrades only.

device on your aftermarket

™

WIRING THE AX-MLINK-AVHD

• Connect the Black wire to the chassis ground.

• Connect the Red wire to 12v accessory power.

Note: It is suggested to add a 3A fuse in-line with

the accessory wire.

• Only make one of the (2) following connections to

the aftermarket in-dash mobile video screen:

• Connect an HDMI

cable (not supplied) from

™

the HDMI

port in the AX-MLINK-AVHD, to the

™

-IN .

HDMI

™

• Connect the Yellow, Red and White RCA jacks

from the AX-MLINK-AVHD, to the AUX/AV-IN.

Note: You can also use the YPbPr 3.5mm connector.

• Connect the (2) Wi-Fi antennas to the interface. It is

best if the antennas are installed outside of the dash

cavity. Also note, both antennas must be used.

(continued on the next page)

CAUTION!

All accessories, switches, climate controls panels, and

especially air bag indicator lights must be connected before cycling

the ignition. Also, do not remove the factory radio with the key in the

on position, or while the vehicle is running.