Axxess AXDIS-VL42 설치 지침 매뉴얼 - 페이지 4

{카테고리_이름} Axxess AXDIS-VL42에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AXDIS-VL42 8 페이지.

• For installations when a double DIN radio will be

installed, the factory radio will need to be disassembled,

and the radio display relocated in the dash.

• Unclip (6) tabs securing the radio bezel to the radio

assembly, then remove the bezel. (Figure C)

• Remove (3) screws securing each radio pod to the

radio frame. Carefully unplug the wiring harness

from each pod, then remove the pods. (Figure D)

• Remove (4) screws securing the radio display to the

radio frame, then remove the display. (Figure D)

• If the vehicle has a factory backup camera, connect the

M.O.S.T. jumper harness to the factory fiber optic cable

from the display screen.

• Connect the AXDIS-VL42 harness to the AXDIS-VL42 interface.

• Connect the AXDIS-VL42 harness to the AXDIS-VL42

chime retention Interface.

• Zip tie the chime speaker under the dash to a location

where it will be heard clearly by the driver, then route

the harness to the radio location.

• Connect the chime speaker to the connector on the

right side of the AXDIS-VL42 chime retention Interface.

• Connect the AXSWC harness to the AXSWC interface,

and then to the AXDIS-VL42 interface.

Note: The factory antenna in these vehicles cannot be

reused. A Metra antenna, 44-UA200 (sold separately),

on the front glass is suggested.

INSTALLING THE AXDIS-VL42 INTERFACE

(Figure C)

(CONT)

(Figure D)