Axxess CHTO-02 설치 지침 매뉴얼 - 페이지 3

{카테고리_이름} Axxess CHTO-02에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess CHTO-02 8 페이지. Chrysler/dodge data interface2002-2008
Axxess CHTO-02에 대해서도 마찬가지입니다: 설치 지침 (4 페이지)

페이지 인쇄

INSTALLATION

1. Connect the 16-pin harness, and the CHTO-02 harness, to the CHTO-02 interface.

2. Connect the CHTO-02 harness to the wiring harness in the vehicle.

PROGRAMMING

Attention! If the interface loses power for any reason, the following steps will need to be

performed again.

1. Cycle the ignition on and wait until the radio comes on.

Note: If the radio doesn't come on within 60 seconds, cycle the key off, then unplug the

interface. Check all connections, reconnect the interface, then try again.

2. Cycle the ignition off, then back on.

3. Test all functions of the installation for proper operation.

AUDIO LEVEL ADJUSTMENT

1. With the vehicle and radio turned on, turn the volume up 3/4 of the way.

2. With a small flat-blade screwdriver, adjust the potentiometer clockwise to raise the audio

level; counterclockwise to lower the audio level.

3. Once at a desired level, audio level adjustment is complete.

REV. 10/9/2019 INSTCHTO-02