Epson 220 매뉴얼 - 페이지 16

{카테고리_이름} Epson 220에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 220 29 페이지. Epson printer parts manual

페이지 인쇄

EPSON LQ-2080

4. Release the left and right sprockets by pulling the sprocket

lock levers forward.

front of the printer

5. Slide the left sprocket to the left margin of the paper using

the scale on the printer. (Printing starts at the arrow mark.)

Then push the lever back to lock it in place.

front of the printer

Note:

For more information on the left margin position, see "Paper

Alignment" and "Printable Area" on page 5.

6. Slide the right sprocket to match the width of your paper,

but do not lock it. Move the paper support midway between

the two sprockets as shown above.

7. Open both sprocket covers. Make sure your paper has a

clean, straight edge and fit the first four holes of the paper,

printable side down, over the tractor pins. Then close the

sprocket covers.

front of the printer

16 - EPSON LQ-2080

paper support

8. Slide the right sprocket to remove any slack in the paper;

then lock it in place by pushing the sprocket lock back.

9. Attach the paper guide and slide the edge guides (

to the middle of the paper guides. Then close the paper

guide cover (

Note:

Always close the printer cover before printing. The printer does

not print when the cover is open.

10. Turn on the printer. You may need to check and change the

printer driver settings. When the printer receives data, it

automatically loads the paper and starts printing. The

printed pages are fed over the paper guide toward the back

of the printer.

After you finish printing, follow the steps in the next section to

tear off your printed document. If the first printed line on your

page appears too high or low, you can fix this using the micro

adjust feature as described in "Adjusting the Top-of-Form

Position" on page 22.

Caution:

Never use the knob to adjust the top-of-form position

while the printer is turned on; this may damage the

printer or cause it to lose the top-of-form position.

The knob can be used when the printer is turned

off only.

2/99

)