Axxess ASWC 설치 매뉴얼 - 페이지 10

{카테고리_이름} Axxess ASWC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess ASWC 13 페이지. Steering wheel control interface

10) After 4 seconds of the led flashing quickly the led will go out for 2 seconds.

11) Then the led will flash, up to 9 times, depending on what radio the ASWC thinks it's connected to.

Here are the led blinks and which radio they represent:

1st led flash is for Eclipse

2nd led flash is for Kenwood

3rd led flash is for Clarion

4th led flash is for Sony and Dual

5th led flash is for JVC

6th led flash is for Pioneer and Jensen

7th led flash is for Alpine*

8th led flash is for Visteon

9th led flash is for Valor

* Note: If the ASWC flashes 7 times and you do not have an Alpine radio connected to it that means

that the ASWC did not see any radio connected. Verify the 3.5mm connector is connected to the

SWC input on the radio.

12) Make sure the number of flashes match what radio you have installed.

13) If the led flashes match the radio then hold down the Volume Down button until the led goes solid

red.

14) Programming for the vehicle and the radio is now complete. Test out the steering wheel control

functions to make sure it works correctly.

If the led flashes do not match the radio you have connected, you must manually program the ASWC

to tell it what radio it is connected to.

1) To manually program the aftermarket radio, press and hold the Volume Up button on the steering

wheel control until the led goes solid red, then release Volume Up.

2) At this point Eclipse is programmed.

If you are using an Eclipse radio go to step 3.

If you are using a different radio go to step 4.

3) Press and hold Volume Down for 5 seconds. The led will flash once then go solid red indicating the

programming has finished. Go enjoy your radio.

axxessinterface.com

800.221.0932