Axxess ASWC 설치 매뉴얼 - 페이지 5

{카테고리_이름} Axxess ASWC에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess ASWC 13 페이지. Steering wheel control interface

For the Auto Detect feature to work there are 3 possible actions, however only one action will be re-

quired by you depending on your vehicle:

1) Turn the ignition on and no other action is required.

2) Turn the ignition on, press and hold down the Volume Up button on the steering wheel.

3) Turn the ignition on, press and release the Volume Up button repeatedly on the steering

wheel.

Like we said before, only one of these actions will need to be done depending on your vehicle for the

auto detect feature to work. Please refer to the vehicle info sheet in the Axxess website.

These are the steps for the Auto Detect Mode:

1) Complete connections to the vehicle and the aftermarket radio.

* If this is the first time the ASWC is being installed in a vehicle:

2) Turn the ignition on; the led will start flashing rapidly which means the ASWC is looking for the

vehicle and the radio.

3) Perform action required for your particular vehicle as noted in the vehicle info sheet.

4) After a couple of seconds the led should stop flashing and not light up for 2 seconds. At this point

do not push any buttons.

5) After the 2 seconds there will be a series of 7 flashes, some short and some long. Make a note of

which flashes were long for this may be needed later.

6) The led will pause for another 2 seconds then flash up to 9 times. Again make a note of how many

flashes.

7) This is the end of the auto detection stage. If the ASWC detected the vehicle and the radio

successfully the led will light up solid red.

8) Make sure the steering wheel control buttons function correctly in the vehicle and enjoy your radio.

So what if the led does not light up solid red? Check out troubleshooting section below.

axxessinterface.com

800.221.0932