Axxess Automobile Parts 설치 지침 매뉴얼 - 페이지 6

{카테고리_이름} Axxess Automobile Parts에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess Automobile Parts 16 페이지. Metra electronics automobile parts user manual

페이지 인쇄

The ASWCSTALK is now configured for the right side.

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on

solid red, it started flashing, or the steering wheel controls did not function

properly. That means the interface did not detect the ASWCSTALK or the

proper radio. Follow these steps to determine what happened:

First some basic tips:

1. Verify that you have 12 volt accessory and a good ground to the

ASWCSTALK and interface.

2. Verify that the 3.5mm connector is connected to your radio securely

and in the correct location.

3. If using the female 3.5mm connector on an Eclipse or Kenwood radio,

verify that the radio's SWC wire is connected to the correct wire on

the interface.

Once all the information above has been verified and correct, you

will need to put the interface back into auto-detect mode. Follow the

instructions from "If the ASWCSTALK was installed before" section above,

however this time take notice of the led flashes in steps 5 and 6. Here is

what the flashes stand for:

LED Feedback

•

The 1st series of led flashes represent the wires that are connected to

the ASWCSTALK.

•

Short flashes represent the steering wheel control wire(s) that are not

connected to the vehicle