Epson 4000 - Stylus Pro Color Inkjet Printer 제품 정보 - 페이지 11

{카테고리_이름} Epson 4000 - Stylus Pro Color Inkjet Printer에 대한 제품 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 4000 - Stylus Pro Color Inkjet Printer 13 페이지. Print engine
Epson 4000 - Stylus Pro Color Inkjet Printer에 대해서도 마찬가지입니다: 브로셔 및 사양 (4 페이지), 제품 참조 매뉴얼 (38 페이지), 여기에서 시작하기 매뉴얼 (6 페이지), 제품 지원 게시판 (17 페이지), 중요 정보 (2 페이지), 제한 보증 (12 페이지), 빠른 참조 매뉴얼 (11 페이지), 브로셔 및 사양 (12 페이지), 브로셔 및 사양 (6 페이지), 설정 매뉴얼 (16 페이지)

10. Push down on the side pin while turning the latch to the

left.

11. Close the top cover when you see a message prompting you

to do so. The cutter moves to the home position.

Replacing the Maintenance Tank

When the maintenance tank is almost full, the message MNT

TK NEAR FULL appears on the LCD panel. When the tank

is completely full, the printer stops working and MNT TK

FULL appears on the panel.

You can check how much space remains in the maintenance

tank by viewing its indicator on the control panel, shown

below. You can also check its status using the SelecType menu

or by printing a nozzle check sheet (page 8).

Maintenance

tank indicator

(showing a

new tank)

Replacement tanks are available from

Epson (part number C12C890071).

Follow these steps to replace the tank:

1. Make sure the printer is not printing or performing any

other operations (READY or PAPER OUT should appear

on the control panel).

2. If you are using 220 ml ink cartridges, remove the four

cartridges from the right ink compartment, then close the

compartment cover.

3. Place your hand under the right ink compartment and

gently pull out the maintenance tank.

CAUTION: Be careful not to spill ink from the tank when

removing it. Hold it upright at all times.

4/04

Epson Stylus Pro 4000

Epson Stylus Pro 4000 - 11