Axxess AXTC-FD3 설치 지침 매뉴얼 - 페이지 3
{카테고리_이름} Axxess AXTC-FD3에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess AXTC-FD3 12 페이지. Ford swc (steering wheel control) and data interface 2020-up
페이지 인쇄
1.
Open the driver's door, and keep open during the programming process.
2.
Cycle the ignition on and wait (5) seconds.
3.
Connect the AXTC-FD3 harness to the AXTC-FD3 interface, and then to
the wiring harness in the vehicle.
4.
Locate the Volume Up button on the steering wheel. Program the interface
Tap Volume Up
by tapping the Volume Up button at a heartbeat pace until the LED light
VOL
+
stops flashing.
5.
The LED light will flash Green & Red while the interface programs the
radio to the steering wheel controls. Once programmed, the LED light will
go out, then produce a pattern which will identify the radio type installed.
Green & Red LED
Green or Red LED
PROGRAMMING
6.
Green & Red LED
Green LED
7.
8.
The LED light will go out, then once again quickly flash Green & Red
while the interface programs itself to the vehicle. Once programmed,
the LED light will go out again, then turn solid Green.
Cycle the ignition off, then back on.
Test all functions of the installation for proper operation.
REV. 10/8/21 INSTAXTC-FD3
3