Epson 4200 정보 매뉴얼 - 페이지 4

{카테고리_이름} Epson 4200에 대한 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 4200 4 페이지. Epson printer information

페이지 인쇄

resolution) will print artwork with white flecks in the solid black. This will allow light

to pass through the black areas and your stamp will end up being solid.

To make laser artwork printed some laser printers and photocopiers dark

enough, follow these simple steps:

Soak a cloth with White Spirit and wipe it once over the printed side of your

artwork. A little black may come off on the cloth. Do not wipe it too hard or with a

dry cloth or you will remove too much black. Run a hot air gun (not a hair dryer)

over the surface of the artwork to flare off the white spirit, if you hold it too close

you will melt the plastic. The surface should now look shiny and the black and

will be dark enough to make stamps with.

Some new laser printers are not affected by white spirit and cannot be enhanced.

If you do not have a laser or an ink jet printer then just photocopy your design onto

the imageblack laser sheets using a standard photocopier.

instructions given above for wiping with white spirit and heating with a hot air gun.

Epson

Laser Model

Resolution

AculaserC1100

600x600 dpi

Panasonic

Laser Model

Resolution

KX-P7200

600 dpi

Laser Model

Resolution

HP1020

600x600 dpi

Konica

Ink Jet Model

Resolution

Magicolor

4800x1200

2400W

dpi

Brother

Ink Jet Model

Resolution

HL 2030

600 dpi

require more detailed information.

Specific Instructions

Wiping with white spirit and heating required.

Specific Instructions

Set to maximum toner in Properties, set to vellum

and FastRes1200, may still need wiping with

white spirit and heating.

Specific Instructions

Set to Best, Black and White and transparency.

Specific Instructions

Does not print black enough.

[email protected]

Then follow the

if you