DigiDesign 96 I/O 매뉴얼 - 페이지 18

{카테고리_이름} DigiDesign 96 I/O에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiDesign 96 I/O 19 페이지. Version 8.0

Gently push the cable connector into the

card's connector. The ridge on the cable connec-

tor must be line directly into the groove on the

card connector. Be very careful not to bend any

of the pins.

Pressing the 50-pin cable connector into the card

Place the top cover onto the 96 I/O and re-

place the screws that you removed with it.

Connect the 96 I/O to your Pro Tools|HD

system.

Press the 96 I/O Power switch.

When you power on the unit, verify that the

LED ring around the power switch lights orange.

Start up the computer.

When you start the computer, verify that the

LED ring around the power switch turns from

orange to green. (If this does not occur, see

"Troubleshooting" on page 14.)

Launch Pro Tools.

96 I/O Guide

Choose Setup > Hardware and confirm that

the new card is recognized:

• If you installed a 96 AD card, you should

see a new tab called Analog In 1–8.

• If you installed a 96 DA card, you should

see a new tab called Analog Out 1–8.

If the new card does not appear in the Hard-

ware Setup dialog, power down, check the seat-

ing of the card, and recheck the cables inside the

96 I/O.

Hardware Setup Changes

Whenever a card is removed or replaced, the

Hardware Setup I/O routing reverts to original

defaults. For more information, see the HD Setup

Guide.

Troubleshooting

If the power ring does not turn from orange to

green when you start the computer, make sure

you reconnected the DigiLink cable to the Pri-

mary port on the back of the unit.

If the DigiLink cable is securely fastened and

the other end is plugged into a Pro Tools|HD

card, you may have inadvertently disconnected

another 50-pin cable when installing the card.