Axxess OESWC-CLASS2H 설치 지침 매뉴얼 - 페이지 5

{카테고리_이름} Axxess OESWC-CLASS2H에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Axxess OESWC-CLASS2H 8 페이지. 03-up class2 harness for oe rf/stk

If the ASWCSTALK is mounted on the right side of the steering column follow the

instructions below. (Auto-detect must be done first)

1. Turn the ignition on

2. Press the MODE on the ASWCSTALK for 10 seconds

3. Then press volume up for 2 seconds

4. The ASWCSTALK is now configured for the right side

Troubleshooting the Auto Detect Mode

So you tried the auto detect feature and at the end the led did not stay on solid

red, it started flashing, or the steering wheel controls did not function properly.

That means the interface did not detect the ASWCSTALK or the proper radio.

Follow these steps to determine what happened:

First some basic tips:

1. Verify that you have 12 volt accessory and a good ground to the

ASWCSTALK and interface.

Once all the information above has been verified and correct, you will need to

put the interface back into auto-detect mode. Follow the instructions from "If the

ASWCSTALK was installed before" section above, however this time take notice

of the led flashes in steps 5 and 6.