DigiDesign D-Control 설치 매뉴얼 - 페이지 9
{카테고리_이름} DigiDesign D-Control에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiDesign D-Control 12 페이지. Desk module
페이지 인쇄
Leveling the Pins on the Rightmost Unit
Each D-Control unit ships with two pins in its right side to an-
chor the units together on the stand. These pins are not
needed on the rightmost unit in your configuration.
To level the roll pins on the rightmost unit:
Identify the unit that will occupy the rightmost position in
1
your configuration.
Use a small hammer to tap in the two pins the right side of
2
until they are flush with the side of the unit. (There is no stop
inside the pin rails, so you will be able to install new pins if
you expand your system later.)
Figure 7. Installing the roll pin in the top of a D-Control unit
Figure 8. Installing the roll pin in the front of a D-Control unit
Top roll pin
location
Front roll pin
location
Installing the Units on the Stand
After the D-Control Main Unit, Fader Modules, and Desk
Modules are prepared for installation, the units are placed on
the stand in the appropriate order for your configuration. In-
stall the units from left to right on the stand.
To install the D-Control units on the stand:
Lift the first unit into place on the stand so the channels in
1
the bottom of the unit go over the rear and front rails of the
stand.
Figure 9. Placing a Desk Module on the stand
Slide the unit to the left side of the stand, leaving a gap of
2
about an inch (2 cm) between the side of the unit and the
flange on the inside of the stand.
Figure 10. Leaving a gap between the unit and stand
Chapter 2: Installing a Desk Module 5