Epson 570e - LQ B/W Dot-matrix Printer 제품 정보 매뉴얼 - 페이지 11
{카테고리_이름} Epson 570e - LQ B/W Dot-matrix Printer에 대한 제품 정보 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson 570e - LQ B/W Dot-matrix Printer 18 페이지. Warranty statement
Epson 570e - LQ B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 빠른 참조 매뉴얼 (15 페이지), 사양 (2 페이지), 제한 보증 (1 페이지)
페이지 인쇄
To avoid peeling labels off the backing sheet and jamming the
printer, follow these steps when you remove continuous paper
with labels from the printer:
1. After you finish printing, tear off the fresh supply of
continuous labels at the perforation nearest the paper
entry slot.
2. Hold down the
button to eject the remaining labels
from the printer.
When using the push tractor, load continuous paper in the rear
slot. For information on when to use the push tractor, see
"Available Paper Paths" on page 8. For instructions on loading
paper on the push tractor and removing a printed document,
see the User's Guide.
To remove the tractor from the push position, follow these
steps:
1. Remove any paper from the tractor.
2. Turn off the printer.
3. Remove the paper guide by holding both edges and lifting
it up.
4. Press the tractor's lock tabs, tilt the tractor up, and lift it out
of the printer.
If a tractor is installed in the pull position, you need to remove
it and install the paper tension unit (as described under
"Removing the pull tractor" on page 12) before using the push
tractor.
To reinstall the tractor in the push position, follow these steps:
1. Make sure the printer is turned off.
2. Remove the paper guide by holding both edges and lifting it
up.
3. Lower the tractor into the mounting slots ( ), and press
down both ends ( ) of the tractor to make sure that it is
firmly seated.
You are now ready to load continuous paper onto the push
tractor. If you need instructions, see the User's Guide.
4/00
EPSON LQ-570e
EPSON LQ-570e
- 11