DigiDesign Mbox 기본 매뉴얼 - 페이지 7
{카테고리_이름} DigiDesign Mbox에 대한 기본 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiDesign Mbox 20 페이지. Version 6.7 for le systems on windows xp or mac os x
페이지 인쇄If your microphone requires phantom power,
3
make sure the microphone is connected, then
press the Phantom Power switch on the back of
the Mbox (labeled 48V). This switch sends 48V
to both mic inputs. The 48V LED on the front of
the Mbox will light when phantom power is be-
ing supplied.
Phantom Power switch
On the front of the Mbox, turn the Mix con-
4
trol fully left to Input.
On the front of the Mbox, carefully turn the
5
Gain control to the right to increase the input
level of your microphone signal.
To use a microphone that has a 1/4-inch
connector:
On the back of the Mbox, plug the 1/4-inch
1
connector from your microphone into one of
the Source inputs. The inputs are numbered
from the bottom up, so Source 1 is the bottom
input.
1/4-inch connector plugged into the Source 1 input
2
Inst (instrument) by pressing the Source selector
until the Inst LED is lit.
Phantom Power
switch
3
trol fully left to Input.
4
Gain control to the right to increase the input
level of your microphone signal.
Channel 1 controls and the Mix control on the Mbox
front panel
Source 2 input
Source 1 input
Do not plug the microphone into the 1/4-
inch jacks labeled "Inserts." These are not
inputs. They are special connectors for us-
ing an external effects processor (such as a
compressor or EQ).
On the front of the Mbox, set the source to
If you are using a microphone with a 1/4-
inch connector, do not choose the "Mic" in-
put source because the Mbox will not regis-
ter any signal.
On the front of the Mbox, turn the Mix con-
On the front of the Mbox, carefully turn the
Inst LED
Source
Selector
Mix control
Connecting a Microphone
5