Epson ActionLaser 1600 사용자 설명서 - 페이지 3
{카테고리_이름} Epson ActionLaser 1600에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ActionLaser 1600 10 페이지. Epson actionlaser 1600: quick start
Epson ActionLaser 1600에 대해서도 마찬가지입니다: 첫 번째 매뉴얼 읽기 (26 페이지), 제품 사양 (2 페이지)
페이지 인쇄
Installing the Lower Paper Cassette Unit
Turn off the printer. Remove any interface cables and
unplug the printer's power cord from the electrical outlet
and from the printer.
Move the printer to one side. Then set the lower cassette
unit where your printer normally rests, keeping the paper
cassette facing you.
Note:
When lowering theprinter, be sure the interface cable is not
pinched between theprinter and the lower paper cassette unit.
Lift the printer and align it over the cassette unit using the
two alignment pins on the lower cassette unit as guides.
Lower the printer so that the pins tit securely into the
holes on the bottom of the printer as shown below.
Note:
Theprinter is heavy, so you may need to have someone help you
lift it.
Reconnect the power cord and the interface cable or cables
you removed and plug the power cord into an electrical
outlet.
Turn on the printer.
Laser Printers
Installing the Face-up Output Tray
1. Hold the output tray tilted at a slight angle away from you.
Then insert it into the back of the printer by placing the
pins on the bottom side corners of the tray into the holes
on each side of the paper ejection slot one at a time as
shown below.
2. Set the paper path selector on the top left of the printer to
the face-up position as shown below.
When you want printed pages to feed face down on top of
the printer, reset the paper path selector to the face-down
position.
Adding Memory
If you are having difficulty printing complex, graphics-
intensive pages or if you regularly use downloaded fonts,
you may want to install additional memory. Your printer's
controller board comes with 2MB RAM installed. To add
memory, you need to install one or two SIMMs on the
controller board. You can thus increase the printer's memory
until it totals 64MB, including the resident memory.
You can purchase SIMMs from various vendors. Be sure the
SIMMs you purchase meet the following requirements:
(1.4 inches), with a diameter of 10 mm (0.4 inches)
5/10/94
EPSON ActionLaser 1600
AL1600-3