Epson ActionLaser II 제품 정보 - 페이지 6
{카테고리_이름} Epson ActionLaser II에 대한 제품 정보을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ActionLaser II 12 페이지. Epson actionlaser actionlaser ii: product information
Epson ActionLaser II에 대해서도 마찬가지입니다: 제품 지원 게시판 (2 페이지)
페이지 인쇄ActionLaser II
There are three
ways to install
and D
C and D
After you have bought the chip sets and decided where to install
them, follow the steps below
1. Locate the DIP switches on the memory board and make sure that
switches 1 and 2 are off, as shown below.
2. Set the remaining DIP switches on the memory board according
to the following table:
I
DIP Switch
5
6
Installing the board
To install
the
memory expansion board, you need a cross-head
screwdriver.
WARNING: Do not remove any screws other than
screws specified in the following steps.
inside the printer when the power is on. Do not attempt to install
memory board unless the printer is turned off and the power cord is
unplugged.
Also, try not to touch any contacts on the
the printer because many of the components can be destroyed by the
static electricity in your body.
1. Unplug
the
power cable
from
2. Disconnect all interface cables from the rear of printer.
ALII-6
chip sets on this board.
ON
c
2.0MB
I D
2.0MB
the
brass-colored
voltages are present
High
circuit board of
the printer,
Remove the two brasscolored retaining screws and
board cover located on the right side of the printer.
Insert the optional memory board
into the printer. Make sure the connectors fit
OFF
Secure the board using the four screws attached to the memory
board.
0.5MB
0.5MB
the
Place
the memory
below. Then, secure the cover using the brass-colored screws.
9/17/91
memory chips installed)
(with
together securely.
board cover over the memory board as shown
the
memory
Laser Printers