DigiDesign 96i I/O 매뉴얼 - 페이지 2

{카테고리_이름} DigiDesign 96i I/O에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DigiDesign 96i I/O 20 페이지. 16-input, 2-output digital audio interface features 24-bit analog-to-digital (a/d) and digital-to-analog (d/a) converters
DigiDesign 96i I/O에 대해서도 마찬가지입니다: 빠른 매뉴얼 (13 페이지), 매뉴얼 (16 페이지)

페이지 인쇄

Avid Technology, Inc. (hereafter "Digidesign"), with all rights

reserved. Under copyright laws, this guide may not be

duplicated in whole or in part without the written consent of

Digidesign.

DIGIDESIGN, AVID and PRO TOOLS are trademarks or

registered trademarks of Digidesign and/or Avid Technology,

Inc. All other trademarks are the property of their respective

owners.

All features and specifications subject to change without

notice.

PN 910611738-00 REV A 09/03

Communications & Safety Regulation Information

Compliance Statement

The model 96i complies with the following standards

regulating interference and EMC:

• FCC Part 15 Class A

• EN55103 – 1, environment E4

• EN55103 – 2, environment E4

• AS/NZS 3548 Class A

Radio and Television Interference

This equipment has been tested and found to comply with the

limits for a Class A digital device, pursuant to Part 15 of the

FCC Rules.

Communications Statement

This equipment has been tested to comply with the limits for a

Class A digital device. Changes or modifications to this product

not authorized by Digidesign, Inc., could void the Certification

and negate your authority to operate the product. This product

was tested for CISPR compliance under conditions that

included the use of peripheral devices and shielded cables and

connectors between system components. Digidesign

recommends the use of shielded cables and connectors

between system components to reduce the possibility of

causing interference to radios, television sets, and other

electronic devices.

Safety Statement

This equipment has been tested to comply with USA and

Canadian safety certification in accordance with the

specifications of UL Standards; UL1419 and Canadian CSA

standard; CSA C22.2 No.1-M90. Digidesign Inc., has been

authorized to apply the appropriate UL & CUL mark on its

compliant equipment.

Important Safety Instructions

When using electric or electronic equipment, basic precautions

should always be followed, including the following:

• Read all instructions before using this equipment.

• To avoid the risk of shock, keep this equipment away from

rain water, and other moisture. Do not use this equipment

if it is wet.

• The equipment should only be connected to the correct

rating power supply as indicated on the product.

• Do not attempt to service the equipment. There are no

user-serviceable parts inside. Please refer all servicing to

authorized Digidesign personnel.

• Any attempt to service the equipment will expose you to a

risk of electric shock, and will void the manufacturer's

warranty.

• The product should be connected only to the correct power

supply as indicated on the product.

Warning!

• HD audio interfaces need room at their sides to maintain

proper air flow and cooling.

• Do not install these units into a rack or other enclosure that

doesn't leave room on either side for the unit fans.

• Do not block the sides of the units (where fans are), or

disconnect the fan.

• If the units are racked up in a case, remove all lids, doors,

or covers before operating the units.

• Failure to do so can result in the units overheating very

quickly, which can permanently damage them.