Epson ActioPrinter 2250 매뉴얼 - 페이지 6

{카테고리_이름} Epson ActioPrinter 2250에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson ActioPrinter 2250 13 페이지. Epson printer specification sheet

페이지 인쇄

ActionPrinter 2250

When you want to push the paper support back into the paper

cassette, first remove paper from the cassette. Then hold down

the locking tab while pushing the paper support in.

The default page length for the paper cassette is 65 lines (A4-size

paper) or 61 lines (letter-size paper). You can change it using

your software or printer commands, if necessary.

You can switch to manual insertion or to the push tractor

without removing the paper cassette.

Loading paper manually

You can load single sheets of paper from the rear manual insertion

slot. (if you've installed the push tractor, remove it before loading

paper manually.)

1. Place the printer in the upright position and turn it on.

2. Next, lower the flap on the rear slot. Then insert a single sheet

into the slot, aligning the paper edge with the arrow mark on the

printer case. The page loads automatically. When the printer

receives data, it begins printing.

tk sure to raise the flap when not using manual insertion.

Be sure to turn on the printer before you insert

CAUTION:

the page into the slot. If you bun on the printer after you

insert paper, the printer prints on the platen without

You can adjust the top-of-form position in the same way that

you do for paper loaded from the cassette.

When you want to switch to the paper cassette, press the

button without inserting a page into the rear slot. The printer

loads a page from the cassette.

AP-2250-6

Using continuous paper with the push tractor

You can use the push tractor to print on continuous paper from

101 mm (4 inches) to 254 mm (10 inches) wide.

Note: The tractor is an option (part number C80026*).

Installing the push tractor

1. Make sure the printer is turned off and is in the flat position.

Remove the paper guide.

2. Make sure the paper-release lever on the left side of the push

tractor

lowered to the single-sheet position.

3. Hold the tractor as shown and fit the edges of both

slots at the back of the printer. Then lift it straight up until

hear the

unit snap into

4. Raise the paper-release lever and push it firmly into the

continuous-paper position.

LF/FF

7/l 4/92

sides

place.

9-Pin Printers

into the