DiGidot 20342 매뉴얼 - 페이지 10

{카테고리_이름} DiGidot 20342에 대한 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. DiGidot 20342 17 페이지.

Mounting

Before mounting and connecting power to the PxLNet Transmitter, make sure to follow these steps:

1. Disconnect power from the DiGidot C4

2. Remove the terminal connector from the DiGidot C4 I/O port

3. Connect the I/O connector of the DiGidot PxLNet Transmitter to the I/O port of the DiGidot C4

controller in upright position and push the connector in straight and ﬁrmly.

4. Install the DiGidot C4 and PxLNet Transmitter by inserting ﬂat hat screws, spaced according to the

drawing down below, in the mounting surface. Leave 4-5 mm between the surface and underside

of the screw heads.

5. Position the mounting holes of both devices over the screws and slide them in place.

WARNING!

This product should not be subjected to high temperatures (risk of fatal damage)

‣

Keep this product away from direct sunlight, rain or other moisture (risk of fatal damage)

‣

Do not use this product outdoors or in humid environments (short circuit risk)

‣

PxLNet Transmitter (20342) Manual

Version 1.8 - November 2021 |

10 17