Arcflash Labs EMG-02 사용자 설명서 - 페이지 11
{카테고리_이름} Arcflash Labs EMG-02에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcflash Labs EMG-02 18 페이지. 10 stage automatic coilgun
페이지 인쇄
Usage of improper armatures in magazines could result in misfires.
2.9 Capacitor
- The EMG-02 contains a large 0.33F capacitor capable of storing up to 600J of energy
- The capacitor may become unsafe if struck, cut, or severely dented
The EMG-02 contains a large electrolytic capacitor at the rear which is used as a
buttstock for the accelerator. The capacitor is attached to the barrel by two large copper bus-
bars internal to the unit. The capacitor is capable of delivering several thousand amperes in
burst current.
There are two electrical safety mechanisms within the gun which protect the capacitor
from reverse bias and overvoltage, and an internal burst valve near the fuse cover in case both
safeties were to fail or physical damage to the capacitor resulted in pressure buildup.
If the capacitor becomes dented, gouged, or deeply scratched we recommend
discontinuing to use the EMG-02 and contact Arcflash Labs for repairs or assessment. Light
scratches to the capacitor case (the black plastic surrounding the aluminum can) are not
hazardous unless the aluminum can itself is damaged or punctured.
There is no inherent danger to touching or handling the capacitor's exterior shell so long
as there is no apparent physical damage to the capacitor or to the EMG-02.
The capacitors require approximately 6 seconds to charge during power-up and 6
seconds to discharge during power-down.
3. Operation
3.1 Startup
MG18 magazine
2575 armature
MG15A magazine
51634 armature
MG15XL magazine
51678 armature
11 |
P a g e