Arcflash Labs SGP-34 사용자 설명서 - 페이지 11
{카테고리_이름} Arcflash Labs SGP-34에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Arcflash Labs SGP-34 13 페이지. Single stage scr coilgun
페이지 인쇄3. Operation
3.1 Startup
- It is unsafe to power up the gun with a magazine inserted.
- Always check that there is nothing inside the barrel before powering up. Any rounds or
debris inside the barrel during startup could result in a misfire.
1. Ensure battery is charged to its nominal voltage of 16.8V.
2. Open battery compartment and connect the battery as shown in section 2.5.
3. Stuff connector and wires into the battery compartment gently, ensure wires clear pinch
points and close the compartment.
4. Insert a magazine into the bottom of the handle, apply force to the bottom of the magazine
to ensure it is fully seated. It may be necessary and it is encouraged to slap the magazine to
ensure it is fully seated against the injector rod.
Insert magazine
5. Activate the main switch.
6. Observe the barrel of the gun, ensure the green LED immediately illuminates; the red LED
should also illuminate 1-2 seconds after activating the main switch. If the red LED does not
Seat magazine fully
11 |
P a g e