Creda Aquathermo 53 series 핸드북 - 페이지 2

{카테고리_이름} Creda Aquathermo 53 series에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Creda Aquathermo 53 series 6 페이지.

페이지 인쇄

Thank you for choosing a quality "Creda" product manufactured in Peterborough, England.

Contents

User information

Page

How to use your shower

Routine Maintenance

How your shower works

Troubleshooting

Available spares

Warning

Do Not Switch The Shower On If You Suspect It Of Being Frozen,

Wait Until You Are Sure That It Has Been Completely Thawed Out.

How To Use Your Shower

Switch On Electricity

at ceiling / isolating switch.

Press Start /Stop Button

in the centre.

(Confirmed with a single bleep)

The unit will start and the motorised valve will reset.

Display will usually light up number 1.

The digit will increase until display shows number 6.

The average showering temperature.

When the unit has got close to this setting it sounds a

double bleep and the unit is ready for use.

The unit will only count up & double bleep once per

shower session.

Flow light will be on high.

To Increase Temperature

- Press the warmer

button once in the centre (Confirmed with a single bleep).

The number will change to the new setting.

i.e. Display will change from digit 6 to digit 7

Wait for a few seconds for the shower to increase the

temperature to the new setting.

Repeat this for your ideal setting waiting each time for the

temperature to be achieved. (Maximum setting is digit 9).

To Decrease Temperature

- Press the cooler

button once in the centre (Confirmed with a single bleep)

The number will change to the new setting.

i.e. Display will change from digit 6 to digit 5

Wait for a few seconds for the shower to decrease the

temperature to the new setting.

Repeat this for your ideal setting, waiting each time for

the temperature to be achieved

Installer Information

Fixing the shower to the wall

Plumbing

Electrical

Commissioning

Guarantee

This page has been left blank for the addition of any notes you may wish to make: -

Page