Creda Florida Spa 핸드북 - 페이지 2

{카테고리_이름} Creda Florida Spa에 대한 핸드북을 온라인으로 검색하거나 PDF를 다운로드하세요. Creda Florida Spa 4 페이지. Shower

Thank you for choosing a quality Creda product manufactured in Peterborough, England
Contents
Information for the user
How to use your Creda Shower . . . . . . . . . . . 2
How your Creda Shower Works . . . . . . . . . . . 3
What to do if things go wrong . . . . . . . . . . . . 4
How to maintain your Creda Shower . . . . . . 4
Additional Accessories / Spare Parts. . . . . . . 7
Information for the installer
Fixing the Shower to the wall . . . . . . . . . . . . 5
Plumbing . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Electrical . . . . . . . . . . . . . . . . . . . . . . . . . . . . 6
Guarantee . . . . . . .. . . . . . . . . . . . . . . . . . . . 8
How to use your Creda Shower
1.
Ensure the electricity and water are turned on to the unit.
2.
Your shower has 3 power settings selected by turning knob "A".
The most popular is "FULL HEAT" indicated by "
you are always only one step away from maximum power.
There are also options for a "HALF HEAT" or "COLD" shower (see notes 8 and 9).
For this example turn knob "A" to "FULL HEAT" (either will do) and set knob "C" to "6 o'clock" on the scale.
3.
Press button "B". Water will flow, 3 lights will illuminate to indicate that the selected power rating is "FULL HEAT".
4.
Allow about 20 seconds for the temperature of the water to stabilise. It is recommended that you do not wholly
enter the water spray during this period, even if the shower has just been used.
5a. If the water is too hot, then increase the flow of water by turning knob "C" clockwise to "7 o'clock" on the scale.
Wait 20 seconds for the temperature of the water to stabilise.
Repeat turning clockwise if necessary until you get the w ater temperature of your liking.
5b. If the water is too cold, turn knob "C" anti-clockwise to "5 o'clock" on the scale and continue as necessary until
you get the water temperature of your liking. The final adjustment may be anywhere on the sc ale.
5c. Basically turning knob "C" anti-clockwise increases the water temperature,
whilst turning clockwise decreases the water temperature.
6.
Once a temperature setting to your liking has been achieved, knob "C" will rarely need adjusting,
eg: adjust for variations of incoming mains water temperature between summer and winter.
7.
When you have finished showering, push button "B" only. You have no need to adjust knobs "A" or "C".
Switch off the electricity at the ceiling switch or local isolator.
8.
The "HALF HEAT
" setting of knob "A" reduces the power used by the shower giving a cooler shower or the option
of reduced water flow. This option is mainly for summer usage and if this is used then knob "C" must be
re-adjusted. On this setting 2 lights will illuminate to indicate that the selected power rating is "HALF HEAT"
9.
The "COLD" setting indicated by "
" of knob "A" will supply water without any heating, and only 1 light will
illuminate to indicate this.
10. Your shower is designed to stabilise temperature changes caused by water pressure fluctuations. These can
result from toilets being flushed or taps bein g turned on and off. When this happens your showering temperature will
be held within a controlled band, provided that the minimum pressure required by the shower is maintained.
11. Your shower requires a minimum operating pressure of 69kPa (0.7 bar, 10 psi). At pressures above 69kPa
(0.7 bar, 10 psi) it will minimizes temperature fluctuations as detailed above in note 10. If the water pressure falls
below 69kPa (0.7 bar, 10 psi) it is likely that the pressure switch will turn off the power to the h eating elements,
resulting in a cold shower. The 2 middle power indication lights will flicker and go out and the "OVERHEAT" light
may come on to indicate this has happened.
12. During normal operation if an overheated water temperature is sensed by the showe r then the thermal cut-out will
switch off the heating elements. The "OVERHEAT" light will illuminate to provide a visual indication that this has
taken place. Water will continue to flow and as the water temperature falls the heating elements will be turn ed back
on. If the "OVERHEAT" light continues to cycle then turn knob "A" to the "HALF HEAT
will need adjusting). If the shower is operated after it has recently been used the "OVERHEAT" light may illuminate
for a few seconds. This indicates that there is still some hot water left in the shower.
Either, wait a few moments for the light to go out or turn knob "C" clockwise.
13. Note that knob "C" IS NOT A TAP and does not turn the water off.
WARNING: DO NOT SWITCH THE SHOWER ON IF YOU SUSPECT IT OF BEING FROZEN.
WAIT UNTIL YOU ARE SURE IT HAS THAWED OUT
Page
" and for your convenience this can be obtained in 2 positions so
" power setting (knob "C"
2
4.
WARNING: THIS APPLIANCE MUST BE EARTHED
5.
Fit the corner section back into the backplate
6.
Fit the front cover back into position making sure the
knobs are aligned correctly with the flow valve and
power selector (see diagram 10).
Start by locating the "tang" around the recess for the
outlet pipe, and then "roll" the front cover over the
knobs and onto the top of the backplate.
Secure the top and bottom fastening screws.
7.
Operate the shower first without the handset to flush
out particles, fit the handset and then opera te the
shower as on page 2 and check:
a. That the water gets to a satisfactory temperature.
b. Water flow can be adjusted by knob "C".
c. Power selection does give a change in water
temperature and power lights illuminate.
d. Check again for leaks
e. That the holes in the spray plate are not blocked
8.
DEMONSTRATE OPERATION TO USER
Additional Accessories / Spare Parts
White 2 metre Shower Hose
Catalogue No. 83-593529
1 metre Riser Rail
Catalogue No. 83-593530
Extended Shower Control Lever
(Interchangeable with Control Knob)
Catalogue No. 83-590710
WRAS listed Water Isolating Valve
Catalogue No. 93-792452
Curtain and Rail Pack
Catalogue No. 83-792802
Curtain and Rail Pack with Non-Slip Mat
Catalogue No. 83-792801
Spare 1.25m long Chrome Shower Hose
Catalogue No. 93-797641
Spare parts/accessories can be supplied against any Credit or Debit cards from Sales Hotline 08 44 372 7750
This appliance is not intended for use by persons (including children and the infirm) with reduced physical,
sensory or mental capabilities, or lack of experience and knowledge, unless they have been given supervision
or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
7