Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 사용자 설명서 - 페이지 35
{카테고리_이름} Epson C11C640001 - LX 300+II B/W Dot-matrix Printer에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson C11C640001 - LX 300+II B/W Dot-matrix Printer 50 페이지. Epson lx-300: user guide
Epson C11C640001 - LX 300+II B/W Dot-matrix Printer에 대해서도 마찬가지입니다: 매뉴얼 (17 페이지)
페이지 인쇄
Selecting a Built-in Font
It is best to use your application program to select the font you want to
use in a document. However, you may sometimes need to select one of
the printer's six built-in fonts using the buttons on the control panel, as
described below. (The settings you make in application programs usually
override settings you make from the printer's control panel.)
❏ Draft
❏ Roman
❏ Sans Serif
Follow these steps to use the control panel to select a built-in font:
1.
Make sure that the printer is on but not printing.
2.
Hold down the Pause button for three seconds to enter
Micro Adjust mode. The Pause light begins to flash and the two
Tear Off (Font) lights show the current font selection.
3.
Press the Tear Off (Font) button repeatedly to cycle through the
fonts, and stop when the lights on the control panel indicate the font
you want. Your selection stays in effect until you change it again.
❏ Draft Condensed
❏ Roman Condensed
❏ Sans Serif Condensed
Using the Control Panel
35