AYC Group LS-5000B 소유자 매뉴얼 - 페이지 4

{카테고리_이름} AYC Group LS-5000B에 대한 소유자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. AYC Group LS-5000B 9 페이지.

AYC Group requires that you contact a local, qualified plumber to install your new

AYC Group pedicure spa. It cannot operate properly or safely unless it is provided

with adequate electrical power, sufficient water pressure, proper water temperature

and the required drain facilities. Information on these important subjects is

contained in this manual. We urge you to read it carefully to make sure these

requirements are met.

1. Excessive water temperature is dangerous and should be checked before use.

Maximum operating water temperature should not exceed 100 F˚ (38 C˚) and the

maximum supply water temperature should not exceed 125 F˚ (65 C˚).

2. Always enter and exit the pedicure spa slowly and carefully.

3. Never bring and/or operate any electrical devices into or near the spa.

4. Do not stand in the whirlpool tub!

Installation Summary

The installation must comply with all plumbing and electrical codes. A licensed plumber

should complete the plumbing of the spa.

Note: Failure to comply with federal, state or local codes and ordinances will result in

warranty being null and void.

Select a level location where the floor structure beneath the spa is capable of supporting

the occupied spa.

For the seat back to fully recline, the spa base must be placed a minimum of 20 inches

from the wall.

Connect the water supply lines with cold and hot inputs.

Connection: Cold

Attach the P-trap to the bottom of the drain with the retaining nut. Be sure to place the

gasket between the brass drain and the P-trap.

Drain and Water inputs

½ NPT

Hot

½ NPT