Archgard 31-LS-WW 설치 매뉴얼 - 페이지 2

{카테고리_이름} Archgard 31-LS-WW에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Archgard 31-LS-WW 16 페이지. Log sets for installation in 345-dvte31ln-1

Overview

The Archgard pan burner bed and fiber logs are designed to give a realistic fire package, and created to look the same as the day they

were originally installed even after many years of use. Care must be given when first installing the logs, and if removed for servicing, as

they can be damaged or broken if not handled properly.

After opening the log set package, inspect the logs to ensure that no damage has occurred inside the package. Please report any

damage immediately to your Authorized Archgard Dealer.

Gas and vent connection must be made before installing the embers and logs on the pan burner.

CAUTION: DO NOT block pilot opening with embers or glass media material.

NOTE: Improper placement of logs and embers may cause soot accumulation on the internal parts and glass. This is not covered under

warranty. Do not use broken or damaged logs.

Many of the logs use the locator pins located on the burner to position the logs. There are holes in the bottom of the log to help align

them to the unique position on the burner.

IMPORTANT: Embers should be placed so as not to completely block burner ports.

NOTE: Installing the fiber logs in any other position other than shown will result in flame impingement causing sooting of the logs, brick

liner and ceramic glass viewing area.

Figure 01:

Failure to position the parts in accordance with these diagrams or failure to use only parts specifically approved with this appliance

Installation

Locator Pins

WARNING

may result in property damage or personal injury.