Epson DM-D500 Series 설치 매뉴얼 - 페이지 31

{카테고리_이름} Epson DM-D500 Series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Epson DM-D500 Series 37 페이지. Customer display
Epson DM-D500 Series에 대해서도 마찬가지입니다: 제품 설명서 (27 페이지), 설치 매뉴얼 (42 페이지), 사양 시트 (2 페이지), 설치 매뉴얼 (38 페이지), 여기에서 시작 (2 페이지)

페이지 인쇄

DIP switch 2

DSW2

Function

No.

2-1

Y-connection (*1)

2-2

Self test selection (*2)

2-3

20 column and 2 line

mode selection (*3)

2-4

Device selection

default setting

2-5

Address 0

2-6

Address 1

2-7

Address 2

2-8

Reserved (*5)

(*1) The "Y-connection enable" is set when a TM printer with no modular jack for the DM-D is

connected with this product, using one COM port to connect both TM printer and DM

display. In this case, an optional DM-D stand (DP-501) and a connecting cable are required.

In cases other than above, choose "Y-connection disabled" (default setting).

(*2) This function can select whether or not you perform self test when turning on the power.

See "Self Test" for details.

(*3) When selecting "20 column and 2 line mode," this product can be used like the

DM-D105/106/205/206. In this case, the graphic display and the original functions for the

DM-D500 cannot be used; however, by selecting "256 × 64 dots mode," they can be used.

(*4) When setting to "Printer is selected," data is sent to the TM printer, but is not displayed on

the display. When setting to "Display is selected," data is displayed on the display but is not

output from the TM printer. The selection can be changed using the <ESC=> command.

(*5) Stays at OFF setting.

Note:

❏ The changes in DIP switch settings are effective when the power is

turned on again.

❏ The data transmission setting, such as data length and transmission

speed, must be the same on both your computer and printer.

Enabled

Perform self test

20 column and 2 line

mode

Printer is selected

The display device number (1-7) corresponds to

Address number 0 to 2. (All OFF is regarded as

no display number.)

−

DM-D500 Installation Guide 29

OFF

Disabled

Do not perform

256 × 64 dots mode

Display is selected

Fixed to OFF

English

Default

setting

OFF