ArchiTech Pro AP-602 설치 매뉴얼 - 페이지 2

{카테고리_이름} ArchiTech Pro AP-602에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ArchiTech Pro AP-602 2 페이지. Rectangular in-wall loudspeakers

페이지 인쇄

For 5-1/4", 6-1/2" & 8" In-Wall

may help reduce hum and RF interference.

When securing the wire, use care not to staple

or nail the electrical conductors. Doing so

could result in a short that might damage the

electronics.

More than two pair of these speakers can

be connected to one amplifier. However, we

suggest that you consult a professional if you

are installing more than two pair.

When connecting your speakers, make sure

proper polarity (phasing) is maintained.

Simply put, this means being sure the same

wire which is hooked to the positive terminal

of the amplifier has its other end hooked

to the positive terminal of the speaker. It is

important to check this on all speakers. If

the connections on one of the speakers are

reversed, (out of phase) the quality of your bass

will be seriously impaired.

INSTALLATION

As the diagrams show, the speakers utilizes

a metal mounting ring which, after tightening

with the screws provided, acts as a clamp to

hold the speakers in place.

To aid in speaker performance, a fibrous material, such

as fiberglass or polyester fiber, may be placed behind

the speaker. This may also help to reduce unwanted

sound from being transmitted into adjoining rooms.

Once you determine where you wish the speakers to be

placed, do the following:

Using the paper template provided, mark the speaker

cut-out location making sure that where you wish the

speakers to be placed will not be obstructed by a stud

or other material hidden in the wall.

Proper use of an electronic stud-

finder is invaluable for this operation.

Using the proper equipment, cut the

appropriate sized hole in the wall.

On drywall, the cleanest cuts will be

made with a drywall saw.

Install the frame and mounting

ring assembly by passing the black

mounting ring through the cut-out

as illustrated. (see figures 1 and 2)

Observe that there is a top and bottom to the frame.

The top and bottom are identifiable by the spacing

between the six vacant screw holes in the black clamp

ring. The more-closely spaced holes are toward the top.

Next, verify that the speaker frame fits into the cut-out.

Rev. A

2-Piece Baffle & Frame

The white frame should fit snugly and smoothly in the

cut-out hole. If the hole should have been cut a little too

large, the flange on the frame should cover this.

Once the frame is in place, gently tighten all of the

screws so that the mounting ring is up against the back

side of the wall board. (see fig. 3) Avoid over-tightening

the screws or it may later become difficult to install the

grille.

If the wire has not yet been run, do so, now that you have

access to the wall's interior. Once the speaker wire has

been run, pull the end of the wire out of the wall, strip

back a section of the jacket as needed, and then expose

½" of each conductor. Connect the wire to the terminals

on the back of the speaker assembly, observing polarity

(+ & -).

Insert the speaker into the frame and install the six

screws. Tighten the screws starting with the middle

pair of screws followed by the top pair and then the

bottom pair. (see fig. 4) Use care not to over-tighten

the screws or it may later become difficult to install the

grille. Install the grilles after testing the operation of the

speakers. The grilles are installed by gently working the

edge of the grille into the frame of the speaker, beginning

at one corner and working one or both directions around

to an adjacent or opposite corner.

page 2 of 2