CREE LIGHTING CONNECTED MAX 빠른 시작 매뉴얼 - 페이지 14

{카테고리_이름} CREE LIGHTING CONNECTED MAX에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CREE LIGHTING CONNECTED MAX 14 페이지. Smart indoor camera
CREE LIGHTING CONNECTED MAX에 대해서도 마찬가지입니다: 설치 지침 (3 페이지), 빠른 시작 매뉴얼 (10 페이지)

페이지 인쇄

Safety Information

Changes or modifications not expressly approved could void your authority to use this equipment.

NOTE: This equipment has been tested and found to comply with the limits for a Class B digital

device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable

protection against harmful interference in a residential installation. This equipment generates, uses

and can radiate radio frequency energy and, if not installed and used in accordance with the

instructions, may cause harmful interference to radio communications. However, there is no

guarantee that interference will not occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be

determined by turning the equipment off and on, the user is encouraged to try to correct the

interference by one or more of

the following measures:

—Reorient or relocate the receiving antenna.

—Increase the separation between the equipment and receiver.

—Connect the equipment into an outlet on a circuit different from that to which the

receiver is connected.

—Consult the dealer or an experienced radio/TV technician for help

FCC Radiation Exposure Statement

This device complies with FCC radiation exposure limits set forth for an uncontrolled environment

and it also complies with Part 15 of the FCC RF Rules. This equipment must be installed and

operated in accordance with provided instructions and the antenna(s) used for this transmitter must

be installed to provide a separation distance of at least 20 cm from all persons and must not be

co-located or operating in conjunction with any other antenna or transmitter. End-users and

installers must be provided with antenna installation instructions and consider removing the

no-collocation statement.

This device complies with Part 15 of the FCC Rules. Operation is subject to the following two

conditions: (1) this device may not cause harmful interference, and (2) this device must accept any

interference received, including interference that may cause undesired operation.

Caution!

Any changes or modifications not expressly approved by the party responsible

for compliance could void the user's authority to operate the equipment.