CREE LIGHTING EDGE ARE-EDG-R4 설치 지침

{카테고리_이름} CREE LIGHTING EDGE ARE-EDG-R4에 대한 설치 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. CREE LIGHTING EDGE ARE-EDG-R4 2 페이지. Led area post top mount

페이지 인쇄

IMPORTANT SAFEGUARDS

When using electrical equipment, basic safety precautions should always be

followed including the following:

READ AND FOLLOW ALL

SAFETY INSTRUCTIONS

DANGER- Risk of shock- Disconnect power before installation.

DANGER – Risque de choc – Couper l'alimentation avant

l'installation.

This luminaire must be installed in accordance with the NEC

or your local electrical code. If you are not familiar with these

codes and requirements, consult a qualified electrician.

Ce produit doit être installé conformément à NEC ou votre code

électrique local. Si vous n'êtes pas familier avec ces codes et

ces exigences, veuillez contacter un électricien qualifié.

SAVE THESE INSTRUCTIONS

FOR FUTURE REFERENCE

TO INSTALL:

Hub Cover

1 of 2

3/8" Set Screws

INSTALLATION INSTRUCTIONS

INSTRUCTIONS D'INSTALLATION

NOTES:

This carton contains complete fixture and fitter assembly.

Tenon mount luminaires used on aluminum, reinforced

fiberglass, or fiberglass poles must be mounted on 3" (77

mm) O.D. tenons.

Make electrical connections to input power supply with

appropriately sized (10-18 gauge) wire nuts. Larger wire

nuts will cause interference problems on tenon mount

luminaires.

MOUNTING TO 3" ROUND TENON

STEP 1:

Remove hub cover and pull fixture supply wires through top of

hub. See Figure 1.

STEP 2:

Slip fixture hub over pole tenon and route supply wires

through the top of the hub.

STEP 3:

Tenon mounted fixtures are provided with a 3" (77 mm) long

rod. After feeding power supply cord up through round hub,

wrap the upper portion of the cord around the rod and tie into

knot. The rod should then be diagonally inserted into round

hub, and positioned so that it rests on the circular inside

edge of hub. See Figure 3. The rod, being held in the hub, will

support the full weight of the power cord running down the

pole, and will relieve any pressure on the connections made

inside the hub.

STEP 4:

Secure the fixture by alternating fastening of eight 3/8"

cup point set screws. See Figure 2. Set screws should be

tightened to

120 in-lbs. (13 N-m)

STEP 5:

Make wiring connections per Electrical Connection section.

STEP 6:

Replace hub cover that was removed in Step 1 after

completing electrical connections.

DIRECT MOUNT TO 4" SQUARE STEEL SHAFT

STEP 1:

Remove hub cover and pull fixture supply wires through top of

hub. See Figure 4 on page 2.

THE EDGE

LED Area Post Top Mount

Includes: ARE-EDG-R3, R4

CI088X02R3_B