CREE LIGHTING KBL EB WIRELESS 설치 지침 매뉴얼 - 페이지 8
{카테고리_이름} CREE LIGHTING KBL EB WIRELESS에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CREE LIGHTING KBL EB WIRELESS 9 페이지. Wireless highbay led luminaire with emergency driver, universal hook and cord or pendant mount with sensor
페이지 인쇄ELECTRICAL CONNECTIONS
NOTE:
Luminaire is intended to be wired to a specific voltage.
Make sure that supply voltage matches voltage on electrical
label next to the junction box. Connecting luminaire to voltage
other than that specified on the label may result in luminaire
damage and/or improper luminaire operation. The emergency
driver must be fed from the same branch as the AC Driver.
ELECTRICAL CONNECTIONS MADE IN JUNCTION BOX
STEP 1:
Supply connections can be brought to the junction
box using customer supplied conduit.
STEP 2:
Using customer supplied 90°C minimum rated wire connectors,
make the following electrical connections within the junction box.
a. Connect the black luminaire lead to
the voltage supply hot lead.
b. Connect the white/red luminaire lead
to the supply switched hot.
c. Connect white luminaire lead to the neutral supply lead.
d. Connect green lead to the supply ground lead.
e. If 0/1-10v Dimming is used, connect the violet
lead to the supply positive dimming lead.
f.
If 0/1-10v Dimming is used, connect the gray
lead to the supply negative dimming lead.
STEP 3:
Locate the two white leads with connectors located inside the
luminaire junction box and connect them.
ELECTRICAL CONNECTIONS MADE WITH CORD
STEP 1:
Supply connections for dimming leads can be brought to
the junction box using customer supplied conduit.
STEP 2:
Make the following connection from the cord
to customer supplied junction box.
a. Connect the black luminaire hot lead
to the voltage supply lead.
b. Connect the red luminaire lead to the supply switched hot.
c. Connect white luminaire lead to the neutral supply lead.
d. Connect green wire lead to the supply ground lead.
e. If 0/1-10v Dimming is used, connect the violet lead to the
supply positive dimming lead in the luminaire junction
box using 90°C minimum rated wire connectors .
f.
If 0/1-10v Dimming is used, connect the gray lead to the
supply negative dimming lead in the luminaire junction
box using 90°C minimum rated wire connectors.
STEP 3:
Locate the two white leads with connectors located inside the luminaire junction box and connect them..
© 2019 Cree Lighting, A company of IDEAL INDUSTRIES. All rights reserved. For informational purposes only. Content
is subject to change. See www.creelighting.com/warranty for warranty and specifications. Cree
registered trademarks of Cree, Inc.
8 of 8
WALL SWITCH
HOT
and the Cree logo are
®
LUMINAIRE
JUNCTION BOX
HOT
BLACK
GROUND
GREEN
NEUTRAL
WHITE
RED (FOR CORD)
SWITCHED HOT
OR
WHITE/RED (FOR
NO CORD)
VIOLET
VIOLET +
ITS
BROWN
BROWN -
DIM (+) VIOLET
VIOLET
DIM (-) GREY
GREY
www.creelighting.com
LPN00814X0001A0_D