Architectural Mailboxes 5500 Series 지침 - 페이지 2

{카테고리_이름} Architectural Mailboxes 5500 Series에 대한 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Architectural Mailboxes 5500 Series 2 페이지. Mailboxes

페이지 인쇄

Thank you for purchase this premium mailbox post. We know you'll be satisfied with the years of service it will provide. If you have any

questions about how to assemble or install this product, or if you need any replacement parts, please call us directly at (310) 374-5700 or

Assembly Instructions

Tools (not included)

Two open end wrenches

Phillips head screwdriver

- or -

Lay post pieces on a flat surface, making sure to align

the screw holes.

Join the two post pieces together using the 3 sheet

metal screws.

Tighten until snug.

Install the assembled post

into the ground as described

in the instructions for the

mailbox. Typical post depths

range from 12"-18" and may

vary based on your

installation application. Pay

particular attention to the

location, height, and distance

from the street.

A concrete footing is

highly recommended for

cantilever style posts.

(310) 374-5700 www.architecturalmailboxes.com

3" Round Mailbox Post with Cover and Finial (Model 7510)

Assembly Instructions

Hardware (included)

To join the two post pieces:

x 3, large sheet metal screws

To join the two decorative covers:

x 4, tapping screws

x 4

Attach the two halves of

the decorative post cover

to each other around the

post using the 4 tapping

screws. The cover will be

slightly loose so that it can

be raised during gardening

or lawn maintenance.

To join the two support arm

To attach the mailbox using

pieces:

the top mounting holes:

x 4, rubber pads

x 6, 3/8" Phillips screws

Press the rubber pads into the

grooves of the support arm

pieces.

Locate the correct height for the

support arm. According to USPS

requirments, the top surface of

the arm should rest from 41" to

45" from the road surface. Refer

to the mailbox instructions for

more details.

Then, attach the arm to the post using

the six 3/8" Phillips screws. Make sure

all screws are even and snug.

To attach the mailbox using

the side mounting holes:

x 4, large hex bolts

x 4, long Phillips screws

x 4x large washers

x 4, nylon spacers (optional)

TO INSTALL USING

TOP MOUNTING HOLES

SIDE MOUNTING HOLES

Attach the mailbox to the post

using the 4 large hex bolts

and 4 large washers.

Attach the mailbox to the post with 4

long Phillips screws.

If you are mounting a wider (T2 sized)

mailbox, insert a spacer in between the

mailbox and post arm at each of the

side hole locations.

Attach the finial to

the top of the post

using the 12mm

Phillips screws.

To attach the finial:

x 2, 12mm Phillips screws

optional