Digiflex CM743 설치 관리자 참조 설명서 - 페이지 3

{카테고리_이름} Digiflex CM743에 대한 설치 관리자 참조 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digiflex CM743 4 페이지. 2g radio module

페이지 인쇄

CLI Triggers

The CLI trigger tables in MENU 6-5-5-1 and 6-5-6-2 can

be used to store a list of telephone numbers that can

trigger an output on the control panel. If you call the

GSM unit from a telephone number that matches a num-

ber in the CLI list then the appropriate output will be

operated.

An output needs to be programmed with an event type

of CLI Trigger and event assignment of 1 or 2 depending

on which table is to be checked.

Simply call the GSM unit from a telephone number that

is programmed in the CLI trigger list to activate the

output.

Module Status

MENU 6-5-0 can be used to obtain various information

on the radio module. The following information is cur-

rently available.

1) Connected Network

2) Signal Strength in dB

3) IMEI Number

4) Radio Firmware Revision

5) SIM Card Present

Dial Number Test

It is possible to check the SIM phone number by select-

ing the dial number test via GSM option in MENU 5-9-5.

SMS Remote Control

The SMS control option in MENU 6-5-6 allow you to pro-

gram up to 10 telephone numbers that are allowed to

send SMS commands to the GSM unit. The first number

in this list is considered as the administrator who will

also receive SMS messages that the GSM unit is unable

to interpret. i.e. any message sent to the radio which

cannot be interpreted will be sent back via SMS to the

first number in the SMS control number list.

Numerous commands can be sent to the panel using

the SMS control functions including arming/ disarming

areas, controlling outputs and doors or checking system

status. The panel can also be requested to send a confir-

mation SMS if required.

The control messages must be sent to the SIM phone

number.

The following table shows the correct method for con-

structing the SMS messages. Note there are no spaces

between the fields only commas as shown.

E&OE

The MyAlarm SMS Control App for iOS and Android

devices is now available and can be used to simplify the

configuration and sending of SMS control messages.

You can search for the app in the app store or scan the

QR codes below using your device's barcode reader for a

direct link to the app.

P/N: CM743IRG Rev 1.6

Page

