ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000 빠른 시작 매뉴얼 - 페이지 4
{카테고리_이름} ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000 18 페이지.
페이지 인쇄CRR-1000 Quick Start Guide
admin@CRR>
2.2 ssh Paramaters
Username: admin
Password: admin
Example:
After successful login, the CLI prompt is displayed:
admin@CRR>
2.3 Help '?' Function
Help is available from the command line by entering the '?' character followed by the <enter> key.
The help function is context-specific, i.e., it provides available options for partial commands, e.g.:
admin@CRR> configure ? <HELP>
Available commands:
configure ares
configure filter
configure frr
configure mangle
configure nat
configure ntp
Entering the '?' character with no preceding command input lists all top-level commands.
2.4 Tab-to-Complete Function
The CLI supports tab completion of commands. If there is more than one option for command
completion, the CLI presents all valid options, as shown below:
admin@CRR> configure
ares
captain
A command history is also provided through the up/down arrow keys, which allows the user to cycle
through previous commands.
3 Common CLI Commands
The following is a list of commonly used commands on the CRR-1000.
3.1 Interface Information (show ip)
To view a router's physical interface information such as hardware address, IP addresses, and link state,
enter "show ip" command, e.g.,:
admin@CRR> show ip
1: lo: <LOOPBACK,UP,LOWER_UP> mtu 65536 qdisc noqueue state UNKNOWN
group default qlen 1
link/loopback 00:00:00:00:00:00 brd 00:00:00:00:00:00
inet 127.0.0.1/8 scope host lo
valid_lft forever preferred_lft forever
- Edit ARES configuration
- Edit packet filtering rules
- Enter FRR configuration shell
- Edit packet mangle rules
- Edit packet NAT rules
- Edit NTP settings
Tab
filter
frr
2
mangle
nat
ntp