ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000 빠른 시작 매뉴얼 - 페이지 8

{카테고리_이름} ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. ARCHITECTURE TECHNOLOGY CORPORATION CRR-1000 18 페이지.

페이지 인쇄

CRR-1000 Quick Start Guide

5.1 FRR Configuration

FRR service uses the open source Free Range Routing project which supports Cisco's IOS-like CLI to

configure the router. Depending on the CRR firmware version used and its corresponding FRR version,

online FRR documentation available at

details. To check which FRR version is running use the following command:

admin@CRR> show version frr

FRRouting 7.3-ATC (CRR).

To start configuring links and routing protocols using FRR's Cisco-like CLI shell use the following

command:

admin@CRR> configure frr

Hello, this is FRRouting (version 7.3-ATC).

CRR#

FRR's shell is similar to the CRR top level CLI shell supporting TAB-complete for possible valid

completions of the partially entered command and also support for "?" to show help in the current CLI

context.

CRR# ?

add

clear

configure

copy

debug

disable

enable

end

exit

find

list

mtrace

output

ping

quit

rpki

show

terminal

traceroute

write

terminal

To star the configuration you have to enter the configure mode by typing "configure terminal". Here is a

full example to configure the IP address 10.1.2.3/24 on interface eth0 with TAB-complete and "?" for

demonstration purposes:

CRR# configure terminal

CRR(config)# ?

access-list

agentx

allow-external-route-update

external processes

banner

bfd

http://docs.frrouting.org/

<HELP>

Add registration

Reset functions

Configuration from vty interface

Copy from one file to another

Debugging functions

Turn off privileged mode command

Turn on privileged mode command

End current mode and change to enable mode

Exit current mode and down to previous mode

Find CLI command containing text

Print command list

Multicast trace route to multicast source

Negate a command or set its defaults

Direct vtysh output to file

Send echo messages

Exit current mode and down to previous mode

Control rpki specific settings

Show running system information

Set terminal line parameters

Trace route to destination

Write running configuration to memory, network, or

<HELP>

covers all configuration options in

Add an access list entry

SNMP AgentX protocol settings

Allow FRR routes to be overwritten by

Set banner

Configure BFD peers