Creek Audio 4040 A 사용 설명서 - 페이지 3

{카테고리_이름} Creek Audio 4040 A에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Creek Audio 4040 A 13 페이지.

OUTPUTS

LINE INPUTS

DIRECT

PHONO INPUT

BALANCED INPUT

USB

COAXIAL

OPTICAL

BLUETOOTH

MAINS CONNECTION

Plug the mains power cord provided into the IEC socket on the rear panel and the mains power plug to the nearest

wall socket or good-quality extension socket strip.

POWER ON/OFF

Move the rocker switch above the IEC mains-socket on the rear panel to the ON position, marked I. The 4040 A will

automatically power-ON and the CREEK logo will be displayed on the front panel for a few seconds before switching

to the HOME screen.

To electrically isolate the amplifier from the mains, move the rocker switch on the back panel to the OFF position,

marked O or remove the power cable.

CONNECTIONS TO THE REAR PANEL

With POWER OFF, connect a good quality speaker cable from each loudspeaker to the output

terminals.

Connect the audio output of a streamer/DAC, or CD Player to either Line 1, or Line 2

(unbalanced inputs) with a good quality stereo RCA-to-RCA interconnect cable.

Line 1 can be set in the Menu as PA Direct, to bypass the pre-amp and feed signals directly to

the power amp from an external pre-amp or volume-controlled DAC, etc.

Line 2 becomes a Phono input with an optional Sequel mk4 module installed.

Connect a streamer, DAC, or CD Player to the balanced inputs with a pair of XLR-to-XLR

interconnect cables.

Connect a computer/laptop or music streamer with a USB (printer) cable, type A to B, or

type C to B, not longer than 5 metres in length.

Connect a CD Transport, Network Streamer, or other digital product with a 75 Ohm RCA-to-

RCA digital coaxial cable.

Connect a CD Transport, Network Streamer, TV, Satellite receiver, or other digital output

device with a good quality optical interconnect.

Screw-in the 10cm antenna provided until it is tight and then swivel it vertically for best

reception range.

Page: