Creek Audio EVOLUTION 50A 사용자 지침 - 페이지 7
{카테고리_이름} Creek Audio EVOLUTION 50A에 대한 사용자 지침을 온라인으로 검색하거나 PDF를 다운로드하세요. Creek Audio EVOLUTION 50A 8 페이지. Integrated amplifier
Creek Audio EVOLUTION 50A에 대해서도 마찬가지입니다: 사용 설명서 (13 페이지), 사용 설명서 (17 페이지)
페이지 인쇄
AM, enter 909. No other entry is required and if this is a valid frequency, the Receiver will
automatically jump to it. It is necessary to select the desired BAND first.
Numeric Pre-set entry:
the handset marked -/-- once or twice to select either a 1 or 2 digit number, shown with one or two
hyphens (- or --). Now press a number or numbers directly from the handset. If a valid memory
address is entered, the Receiver will tune to it.
STORE adds stations to memory. Press STORE for 2 seconds; when the display flashes, select a
number using SEL up / down, or use the default number flashing and press STORE again briefly, to
memorize the station into a pre-set address.
SEL, Press the top or bottom of the blue button to tune to the next Pre-set.
<< >>
TUNE moves the frequency up / down.
I<< >>I
SEEKs up / down.
INFO operates the same as on the front panel.
TIME displays the actual time derived from RDS information. It cannot display unless an
FM –RDS station is tuned.
Technical specification
FM Frequency range in total
Tuning Increments
Pre-set stations
Station programming
Sensitivity (Audio SINAD = 26dB max RF gain)
Image rejection
Adjacent Channel rejection
Alternate channel rejection
Frequency response
Total harmonic distortion
Stereo separation
Signal to noise
De-emphasis
Page 7
Select pre-set mode, via the green MODE button. Use the button on
76 - 108 MHz (selectable for region)
50, 100 and 200 kHz (selectable for region)
99
Manual or Automatic
-3.5 dBuV
>70dB
>65dB
>70dB
30 Hz- 16 kHz -1dB
<0.1%
>40dB
>70dB (Full limiting) Stereo
50 or 75 µsec selected for region