Creek Audio CD50 사용 설명서 - 페이지 3
{카테고리_이름} Creek Audio CD50에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Creek Audio CD50 17 페이지. Creek audio compact disc player operating instructions cd53, cd50
페이지 인쇄SAFETY WARNINGS
SPECIFICATION
Power requirements
and fuse rating:
Power consumption
Frequency response
Output level, unbalanced
Balanced
Output impedance
Output balanced
Laser type
Wavelength
Light output (cw)
Signal to noise ratio
Dynamic range
Number of channels
Total harmonic distortion
Dimensions CD53
Dimentions CD50
Weight
N N O O T T E E
The equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to Part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in residential installations.
This equipment generates and can radiate radio frequency energy and if not installed and used in accordance with the
instructions may cause interference to radio communications. However, there is no guarantee that interference will not occur in
some instances. If this product causes interference to radio or television reception, which can be determined by turning the
equipment off and on, try to correct this by one or more of the following measures:
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and the radio or TV receiver.
Connect the equipment into a mains outlet on a circuit different from that to which the receiver is connected.
Consult the dealer or an experienced radio/TV technician.
AC 220-240 V 50 Hz - T 250 mA
AC 110-120 V 60 Hz - T 500 mA
20 W max 6 W standby
1 Hz - 20 kHz ± 0.25 dB
2.2 V RMS at 1kHz, 0 dB
4.4 V RMS at 1kHz, 0dB
100 W , min load 1 kW
200 W , min load 1 kW
Semiconductor ALGaAs
790 nm ± 25 nm
0.18 mW typical
better than 96dB's
better than 96dB's
2
< 0.0015% at 1 kHz, 0 dB
43 x 7 x 25 cm
43 x 6 x 23 cm
5 Kgs
CD53 & CD50
CAUTION!
Invisible laser radiation
when top cover is
removed.
Class 1 Laser Product
OTHER FEATURES
1.
Infra-red remote control.
2.
High precision DS digital to
analogue conversion.
3.
Advanced DEM (dynamic element
matching) technology.
4.
Low jitter filtered master clock
5.
3-beam optical laser pick up.
6.
16 program memory.
7.
VFD display.
8.
Shuffle function (random selection).
9.
Repeat facility.
10.
Intro scan facility.
11.
A-B playback facility
Note:
The specification and design are subject to
change for improvements without notice.
Compact Disc Player
CAUTION
PERFORMING
ADJUSTMENTS OR
PROCEDURES OTHER
THAN THOSE
SPECIFIED HERE MAY
RESULT IN
HAZARDOUS
EXPOSURE.
THE CD PLAYER
SHOULD NOT BE
REPAIRED BY
ANYONE EXCEPT
QUALIFIED SERVICE
PERSONNEL.
3