Archlit LeeSti BrytDyt Trimless 45 Degrees 설치 지침 매뉴얼 - 페이지 2
{카테고리_이름} Archlit LeeSti BrytDyt Trimless 45 Degrees에 대한 설치 지침 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Archlit LeeSti BrytDyt Trimless 45 Degrees 7 페이지.
페이지 인쇄LeeSti BrytDyt Trimless - 45
Installation Instructions
Installing fixture frame
Drywall cutout
7. Insert feed wire from Remote drivers into fixture frame
through feed wire hole on U-channel at fixture ends to
connect to LED module wires later. Make sure to use
wire bushing (provided) in hole to avoid wire cutting.
8. Insert fixture frame into drywall cutout till trimless flanges
touch drywall. Secure it to drywall using drywall screws
(not provided) at marked locations on each trimless
flange/extrusion.
9. Finish wall\ ceiling by covering trimless flange with mud.
Donot applying mud on inner surface of trimless extrusion.
Make sure front surface of magnets (present inside frame)
remain free from dust.
archlit
42 Ithanell Rd Hopatcong, NJ 07843 USA P 973.577.4400 www.archlit.com
Feed wire from
Remote drivers
Drywall screws
Fixture frame
Step 9 : Drywall Finish /
Applying mud
v
through wire hole in frame
Step 8 :
Securing fixture frame
to drywall
Fixture after applying mud
P/N # 493.45-823
a r c h l i t
architecture lit
Wire hole
bushing
Passing feed wire
from Remote drivers
( Step 7 )
Drywall screws
Magnets
Page 2 of 7