Creek Audio AMBIT TUNER 사용 설명서 - 페이지 3

{카테고리_이름} Creek Audio AMBIT TUNER에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Creek Audio AMBIT TUNER 10 페이지. Plug-in fm/am tuner

Insert the Flat Foil Cable (FFC), exiting from the AMBIT module, into the appropriate

socket on the Pre-amp PCB below it, marked MODULE. The AMBIT PCB should now be

held upside-down (components facing down, bare PCB facing upwards) with the antenna

sockets facing backwards towards the rear panel. Fold the loose FFC under the AMBIT

PCB.

1. For EVOLUTION 50A version 1: Push the antenna sockets through the appropriate

holes on the rear panel. Using the retained screw, fix the AMBIT module firmly onto

the rear panel, using the Torx T7 screw driver supplied in the pack.

2. For EVOLUTION 50A version 2: Line the plate up with the expansion slot in the

rear panel. Using the screws previously removed, fix the AMBIT module firmly onto

the rear panel, using the Torx T7 screw driver, supplied in the pack.

Replace the cover as before, making sure to put the cutting washer back on the same

screw position.

CONNECTING ANTENNA

To get you started quickly, Creek Audio has included a 1.5 metre length of wire with a

co-ax plug at one end, to act as a temporary FM antenna. Adjust the position of this tem-

porary antenna for best results. However, to obtain the best FM signal, use a high quality,

multi-element, directional external VHF - FM antenna. If in doubt consult your supplying

Hi-Fi dealer, or a specialist antenna installation company for advice.

An AM loop antenna is also supplied for indoor use only. Connect the two-wire loop anten-

Page: 2