Digigram LX1616ESe 사용자 설명서 - 페이지 3
{카테고리_이름} Digigram LX1616ESe에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digigram LX1616ESe 14 페이지. Ethersound pci express sound cards
Digigram LX1616ESe에 대해서도 마찬가지입니다: 사용자 설명서 (15 페이지)
페이지 인쇄
1 Information for the user
This device complies with part 15 of FCC rules. Operation is subject to the following two conditions: (1)
This device may not cause harmful interference, and (2) This device must accept any interference
received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a CLASS B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses, and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions
contained in this data sheet, may cause harmful interference to radio and television communications.
However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be
determined by turning the equipment off and on, the user is encouraged to try to correct the interference
by one or more of the following measures:
* reorient or relocate the receiving antenna
* increase the separation between the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
Note: Connecting this device to peripheral devices that do not comply with CLASS B
requirements or using an unshielded peripheral data cable could also result in
interference to radio or television reception.
To ensure that the use of this product does not contribute to interference, it is necessary to
use shielded I/O cables.
The user is cautioned
Digigram could void the user's authority to operate this equipment.
Warning:
Electrostatic discharge (ESD) can
components on the board. To avoid
the
board,
Bring the device and everything that
potential by providing a conductive
paths. As a minimum, observe these precautions:
●
Disconnect all power and signal sources.
●
Place the device on a grounded conductive work surface.
●
Ground yourself via a grounding wrist strap or by holding a grounded object.
Ground any tool that will contact the device.
●
IMPORTANT NOTICE
This card has been tested and found to comply with the following standards:
●
International: CISPR22 Class B.
●
Europe: EMC 89/336/CEE (1992) specifications.
●
United States: FCC Rules-Part 15-Class B (digital device).
2
LX6464ESe & LX1616ESe user guide
that any changes or modifications not expressly approved by
take
the
following
harmful
damage
several
such damage in handling
precautions:
contacts
it
to
ground
surface
and
discharge