Digigram PCX-IP LW1221e 사용자 설명서 - 페이지 5

{카테고리_이름} Digigram PCX-IP LW1221e에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digigram PCX-IP LW1221e 20 페이지. Professional multichannel sound cards with livewire connectivity

페이지 인쇄
Digigram PCX-IP LW1221e 사용자 설명서
INFORMATION FOR THE USER
This device complies with part
 
 
 
 
 
2
and (
) This device must accept any interference received, including interference that may cause undesired operation.
This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to Part
 
 
 
 
designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio
   
 
frequency energy and, if not installed and used in accordance with the instructions contained in this data sheet, may cause harmful interference to radio
 
 
   
 
and television communications. However, there is no guarantee that interference will not occur in a particular installation.
If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user
 
 
 
 
 
is encouraged to try to correct the interference by one or more of the following measures:
* reorient or relocate the receiving antenna
* increase the separation between the equipment and the receiver
* connect the equipment into an outlet on a circuit different from that of the receiver
* consult the dealer or an experienced audio television technician.
Note: Connecting this device to peripheral devices that do not comply with CLASS B requirements or using an unshielded peripheral data cable
could also result in harmful interference to radio or television reception. The user is cautioned that any changes or modifications not expressly
approved by the party responsible for compliance could void the user's authority to operate this equipment. To ensure that the use of this product
does not contribute to interference, it is necessary to use shielded I/O cables.
Warning:
Electrostatic discharge (ESD) can damage several components on the board. To avoid such damage in handling the board, take the following
 
 
precautions:
Bring the device and everything that contacts it to ground potential by providing a conductive surface and discharge paths. As a minimum, observe
 
 
 
 
these precautions:
●
Disconnect all power and signal sources.
●
Place the device on a grounded conductive work surface.
●
Ground yourself via a grounding wrist strap or by holding a grounded object.
●
Ground any tool that will contact the device.
Due to the reduced length of the PCI EXPRESS
the PCIe
®
 card(s) installed in a computer, unless its chassis or case provides a dedicated support to keep the card securely in place in order to avoid
physical damage.
IMPORTANT NOTICE
This card has been tested and found to comply with the following standards:
●
International: CISPR22 Class B
●
Europe: EMC 89/336/CEE (1992) specifications
●
United States: FCC Rules­Part 15­Class B (digital device)
In order to guarantee compliance with the above standards in an installation, the following must be done:
●
the provided cable must not be modified
●
additional cables used must have their respective shield connected to each extremity
5
15
   
of FCC rules. Operation is subject to the following two conditions: (
 
 
   
 
 
   
 
 
 
 
 
 
 
 
   
 
   
   
 
 
 
 
 
 
     
 
TM
 bus connector and the resulting lack of mechanical stability, we strongly advise against transporting
   
 
 
 
 
 
   
   
 
     
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
 
   
PCX-IP LW881e, PCX-IP LW1221e
1
 
) This device may not cause harmful interference,
 
 
 
 
15
 
   
 
   
of the FCC Rules. These limits are
 
 
 
   
 
 
 
 
 
 
 
 
 
 
 
   
 
 
 
 
 
User's manual