Digigram EtherSound Aqonda 8 사용자 설명서 - 페이지 4

{카테고리_이름} Digigram EtherSound Aqonda 8에 대한 사용자 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digigram EtherSound Aqonda 8 20 페이지. Ethersound audio bridges

페이지 인쇄

INFORMATION FOR THE USER

This equipment has been tested and found to comply with the limits for a CLASS B digital device, pursuant to

Part 15 of the FCC Rules and with the following European and international Standards for:

User safety

International :

IEC 60950 1 (2005)

Europe :

European Directive 2006/95/EC "Low Voltage Directive"

EN60950 1 (2006)

RoHS:

European directive 2002/95/EC aka "RoHS"

In order to guarantee compliance with the above standards in an installation, the following must be done:

the provided cables must not be modified

additional cables used must have their respective shield connected to each extremity

shielded network cables shall be used

The limits specified in the standards are designed to provide reasonable protection against harmful interference in an industrial

installation. This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with

the instruction, may cause harmful interference to radio communications. However, there is no guarantee that interference will not

occur in a particular installation.

If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment

off and on, the user is encouraged to try to correct the interference by one or more of the following measures:

* reorient or relocate the receiving antenna.

* increase the separation between the equipment and the receiver.

* connect the equipment into an outlet on a circuit different from that to which the receiver is connected.

* consult the dealer or an experienced audio/television technician for help.

Note:

Connecting this device to peripheral devices that do not comply with CLASS A requirements or using an unshielded peripheral data

cable could also result in harmful interference to radio or television reception. The user is cautioned that any changes or modifications

not expressly approved by the party responsible for compliance could void the user's authority to operate this equipment. To ensure

that the use of this product does not contribute to interference, it is necessary to use shielded I/O cables.

Aucune partie de ce manuel ne peut être reproduite sans l'accord préalable de Digigram. Cette réserve inclut la photocopie, la traduction et/ou la remise

en forme de l'information contenue dans ce manuel.

Bien que tout ait été mis en œuvre pour assurer la plus grande précision, Digigram ne peut être tenu responsable pour toute erreur, faute de frappe ou

omission et se réserve le droit d'apporter des modifications et des améliorations sans préavis.

Digigram and the Digigram logo, EtherSound, AQONDA 8, et AQONDA 16 sont des marques déposées ou des marques commerciales de Digigram

S.A.. Toutes les autres marques sont la propriété des sociétés respectives.

La technologie EtherSound est protégée par des brevets et des demandes de brevets internationaux, y compris, mais pas limitée à :

WO 03/023759, FR 2 829 655, USA 2003/0050989

EMC

International :

CISPR22 (2005) Class B + A1/2005 + A2/2006

United States :

FCC rules Part 15 Class B

Europe :

European Directive : EMC 2004/108/EC

Disturbance Emissions: EN55022 (2006) +A1/2007 Requirements for

Information Technology Equipment (ITE)

Immunity: EN55024(1998+A1/2001+A2/2003) (ITE)

Harmonics: EN61000-3-2 (2006)

Voltage fluctuation and flickers test EN 61000-3-3 (1994+A1/2001+A2/2005)

Note: to comply with standard EN55024, use shielded network

cables!

Aqonda 8/16

Ethernet Audio Switches