Creo iQsmart 2 사용자 설명서 부록 - 페이지 13

{카테고리_이름} Creo iQsmart 2에 대한 사용자 설명서 부록을 온라인으로 검색하거나 PDF를 다운로드하세요. Creo iQsmart 2 16 페이지.

For reflective:

•

Tape the reflectives to the reflective side of the mask, according to

the format you want to define. Make sure the image side is up and

in the correct orientation.

The first original should be near the 0,0 point at the lower left

corner of the mask. Taping the originals is similar to direct

mounting in multi preview (see Direct Mount on page 24), but here

you proceed from left to right. Make sure not to cover the barcode

windows.

•

To mount in the scanner, turn the mask over so that the

transparency label of the mask faces up; insert the mask

registration holes into the registration pins of the glass.

The 0,0 corner of the mask is approximately above the 0,0 corner of the

Base glass.

The following figure illustrates the prepared mask mounted for

reflective scan.

Since the reflective is taped to the other side of the mask, it is not shown in the

figure.

Chapter 2 Preparation

Transparency side