Digikeijs DR 4088 series 사용 설명서 - 페이지 6

{카테고리_이름} Digikeijs DR 4088 series에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digikeijs DR 4088 series 12 페이지. Feedback module
Digikeijs DR 4088 series에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지)

페이지 인쇄
Digikeijs DR 4088 series 사용 설명서
DR4088CS / GND / OPTO

3.0 Programming

First, something fundamental about the S88(N) Bus®:
•
The S88(N)® bus is a universal bus system.
•
The S88(N)® bus supports a maximum of 256 feedback addresses.
•
The addresses are always assigned automatically and continuously. No universal and unique addressing is possible because the S88(N)® bus is not desig-
ned for individual address assignment!
•
The S88(N)® can only be set up as a bus (line) network. This always means from 1. feedback to 2. feedback, etc.
3.1 Programming DR4088xx (Assign start address in DR50xx)
The S88(N)® bus system does not provide programming in the actual sense. It only has to be defined in the central with which address the S88(N)® bus starts
and how many modules are located on the bus.
Programming the start address in the DR50xx
1.
Start the DR50xx tool.
2.
Call up the settings for the S88(N)® bus with the button in the ext88N tool.
3.
The start address and the number of modules must now be entered in this input mask.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-08-11
P 6