Digikeijs DR4088OPTO 사용 설명서 - 페이지 9
{카테고리_이름} Digikeijs DR4088OPTO에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digikeijs DR4088OPTO 14 페이지. Feedback module
Digikeijs DR4088OPTO에 대해서도 마찬가지입니다: 사용 설명서 (11 페이지), 매뉴얼 (8 페이지), 사용 설명서 (12 페이지), 사용 설명서 (15 페이지)
페이지 인쇄
DR4088RB-CS / OPTO
3.2.2 Programming with the Z21® and the maintenance tool.
1.
Press the key on the DR4088RB-xx, the green LED starts flashing.
2.
In the Maintenance Tool, send module address 1 to the DR4088RB-xx via the Program button.
3.
Always confirm the procedure with OK until the end of the dialog.
4.
The green LED now flashes again as at the beginning.
5.
Now press the key on the DR4088RB-xx twice in quick succession.
6.
The green LED now flashes at a different rate than before.
7.
In the Maintenance Tool, send the module address 4,6,8 or 10 to the DR4088RB-xx via the Programming button, depending on the
number of available modules.
8.
Always confirm the procedure with OK until the end of the dialog.
9.
The green LED now flashes again as at the beginning.
Please refer to the instructions above for programming the number of modules.
Example:
DR4088RB-xx —>
DR4088xx
Module address 1
Number of modules = 4 (x 8 feedback units)
DR4088RB-xx —>
DR4088xx —> DR4088xx —> DR4088xx —> DR4088xx
Module address 1
Number of modules = 10 (x 8 feedback)
3.3 Reset DR4088RB-xx
Important! The DR4088RB-xx The DR4088RB-xx has no function for resetting to factory settings!
This is also not necessary because no other functions can be set in the DR4088RB-xx except for the module address and the number of modules.
To reset the module address back to the basic setting 1, it is sufficient to send it again to the DR4088 RB as described above. For the number of
modules 2 more modules have to be sent to the DR4088RB-xx. Further steps are not necessary.
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-07-06
P 9