Digikeijs DR4088RB-CS 사용 설명서 - 페이지 7
{카테고리_이름} Digikeijs DR4088RB-CS에 대한 사용 설명서을 온라인으로 검색하거나 PDF를 다운로드하세요. Digikeijs DR4088RB-CS 14 페이지.
Digikeijs DR4088RB-CS에 대해서도 마찬가지입니다: 매뉴얼 (8 페이지)
페이지 인쇄
DR4088RB-CS / OPTO
3.1.2 Programming with the Z21® and the Maintenance Tool.
1.
Press the 1st key on the DR4088RB-xx, the green LED starts flashing.
2.
In the Maintenance Tool, send module address 1 (3,5,7, etc.) to the DR4088RB-xx via the Programming button.
3.
always confirm the procedure with OK until the end of the dialog.
4.
The green LED flashes again as at the beginning.
5.
Press the key on the DR4088RB-xx twice in quick succession.
6.
The green LED now flashes at a different rate than before.
7.
In the Maintenance Tool, send module address 2 to the DR4088RB-xx via the button Program.
8.
always confirm the procedure with OK until the end of the dialog.
9.
the green LED flashes now again as at the beginning.
Please refer to the instructions above for programming the number of modules, for.
example:
DR4088RB-xx —>
DR4088RB-xx
Module address 1
Module address 3
Number of modules = 2
Number of modules = 2
DR4088RB-xx —>
DR4088RB-xx —>
Module address 1
Module address 3
Number of modules = 2
Number of modules = 2
www.digikeijs.com
® R-Bus, B-Bus are trademarks which are registered in the name of Modelleisenbahn GmbH. XpressNet and RS-Bus is a trademark registered in the name of Lenz
2021-07-06
DR4088RB-xx
Module address 5
Number of modules = 2
DR4088RB-xx
DR4088RB-xx
Module address 7
Module address 9^
Number of modules = 2
Number of modules = 2
P 7