Digilent chipKIT DP32 참조 매뉴얼 - 페이지 3

{카테고리_이름} Digilent chipKIT DP32에 대한 참조 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Digilent chipKIT DP32 18 페이지. Board
Digilent chipKIT DP32에 대해서도 마찬가지입니다: 참조 매뉴얼 (10 페이지)

페이지 인쇄

12/21/2018

The DP32 has the following hardware features:

1. J3 – Digital and Analog I/O Connector #2

The set of Digital I/Os with chipKIT numbers 9 through 18 and Analog pins

A3-A8. The holes are slightly offset to allow for friction fitting of headers. See

the Pinout Diagram and Pinout Table for more details.

Rev C change: The silk screen on Rev B (image →) shows the port assignments

as used with MPLAB, not the MPIDE pin assignments. Also, the holes are not

offset, requiring headers to be soldered to the board.

2. JP1, JP2 & JP3

JP1 – USBID Jumper for use with USB OTG:

This jumper allows Digital I/O pin 0 (RB5) to be disconnected from the USBID line on the USB Port. If JP1 is shorted, pin 0 may not

operate as expected. Some users may wish to keep JP1 shorted for USB operations.

JP2 and JP3 – D+ and D- USB Signals:

These jumpers are shipped unloaded. The trace between the two terminals may be cut if USB functionality is required to be permanently

disabled. Once the traces have been cut, it is possible to solder jumper pins in these locations to re-enable the D+ and D- signals as

desired.

3. J2 – USB Connector for USB Serial Converter

This connects to a USB port on the PC to provide the communications port for the MPIDE to talk to the DP32 board. This can also be

used to power the DP32 when connected to the PC.

4. J6 – External Power Screw Terminal Connectors

This screw terminal connector may be used to provide up to 15VDC to the DP32. The polarity of the terminals is marked on the

silkscreen and must be followed to avoid damaging the board.

5. JP7 – Power Select Jumper

This jumper may be set to either power the DP32 via USB (J2), or Screw Terminal (J6). To power via USB, set the jumper to short the

pins with VIN and VUSB directly to their right. To power via external supply, short the two pins nearest the screw terminal.

https://reference.digilentinc.com/chipkit_dp32/refmanual

chipKIT DP32 Reference Manual [Reference.Digilentinc]

3/17